Computer Hardware Tutorials – Installing a Laptop Tough Drive

Jun 12, 2012 by DelilloDress261

1 of the handful of components which is simply upgradable in practically all portable computers is the challenging drive. Laptop computer systems these days all use the SATA interface which is specifically the identical as that employed in desktop computer systems. The only distinction in between laptop and desktop tough drives is that the former are smaller with a 2.5″ form aspect although the latter have a three.five” form factor. In reality, it’s attainable to set up a laptop tough drive into a desktop computer. Installing a laptop tough drive into your notebook personal computer is a straightforward approach and every bit as straightforward as installing one particular in a desktop.

Needs: Totally free SATA challenging drive bay
What you require: Small Phillips screwdriver
Time necessary: 10 minutes
Difficulty: Effortless

Step 1 – Preparations

Make sure that your laptop is turned off just before continuing. Unplug the power cable and get rid of the battery pack from its bay in the bottom of the machine. Turn the computer system upside-down and find the hard drive cover panel. This is commonly a rectangular panel in 1 of the corners of the machine, about three.5 inches wide. It will usually be held in place by two screws. Some laptops might have a single panel which covers the whole bottom of the computer system. Eliminate the panel covering the drive bay.

Step 2 – Eliminate the Current Drive

Typically, you will find a small screw underneath the challenging drive bay cover panel. This screw will connect a small metal notch at the side or front of the difficult drive to the metal frame of the pc. Once you have removed this, you really should be able to slide the hard drive backwards with little effort. As soon as it comes free of charge from the sockets, basically lift it out of the drive bay and location it aside.

Step three – Set up the New Drive

Basically slide the new drive into the drive bay, pushing it into the power and SATA sockets. Unlike with a desktop computer system, there are no cables to connect. With the difficult drive firmly seated in spot and effectively connected, put the screw back in the metal tab at the back or side of the drive (if applicable) to repair it in spot. Put the drive bay cover back on, making certain that all of the tabs are locked in spot prior to putting the screws back. Your new challenging drive should be prepared to use as soon as you turn the personal computer on again.

For more, please go to: discount hp