Right here are the steps you’ll need to adhere to for installing your new bathroom vanity, Shut off the water and disconnect the supply, use a bucket to catch any water that drips from the provide lines and the p-trap the white curved pipe in the center.

Loosen the caulk between the bathroom vanity and the wall with an utility knife. You may have to go all the way down to the floor on the sides to eliminate all the caulk. Get rid of the countertop extremely carefully so as not to damage the wall, you could need a helper for this step, particularly if the countertop is big.

Loosen the screws attaching the bathroom vanity to the wall. A cordless screwdriver makes it less difficult to do this step. Take away the screws, getting cautious not to strip them. Take away the old vanity. Find the wall studs and make marks for new screw holes. Make the marks for the studs a small larger than the leading of the new vanity.

It is really critical to make confident the bathroom vanity is flush against the wall. You are going to need to have to use shims and a carpenter’s level for this step. As soon as the vanity is positioned, attach it to the wall with two-1/2″ wallboard screws.

Before you attach the new bathroom vanity top rated, set up the new faucet. It will make the job go faster in the extended run, and it really is one less time that you are going to have to get beneath the sink. Use tub-and-tile caulk to secure the bathroom vanity best to the base.

Reconnect the plumbing this is also a great chance to replace the p-trap. Teflon tape makes the connections simpler and tighter. Cautiously apply a thin line of caulk about the countertop edges. Be cautious with this job, the caulk will be extremely visible, so tidiness actually counts.

For more, please go to: the best