What Are Corning (Siecor) Unicam Connectors? Fiber Optic Tutorial Series 1

Aug 19, 2012 by FowlerOna837

For regular epoxy and polish fiber optic connectors, the termination process typically contains 7 actions (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes depending on your fiber) fiber cladding

two. Clean the exposed bare fiber with isopropyl alcohol and lint-cost-free wipes

3. Insert the bare fiber into the connector center hole till …

The termination process for sector common epoxy and polish fiber optic connectors.

For normal epoxy and polish fiber optic connectors, the termination procedure typically includes 7 steps (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes depending on your fiber) fiber cladding

two. Clean the exposed bare fiber with isopropyl alcohol and lint-free wipes

three. Insert the bare fiber into the connector center hole till the fiber stops

four. Inject fiber optic epoxy with a syringe dispenser into the connector physique

5. Cure the fiber optic epoxy with high temperature which could be 85C, 100C or even 120C based on the sort of fiber optic epoxy(you need to have a special connector epoxy curing oven for this purpose)

6. Scribe the fiber protruding from the tip of the fiber connector

7. Polish the connector tip with lapping films either by hand or specialized fiber optic connector polishing machine(specifically for single mode fiber connectors)

So you see that the approach for terminating optical fiber is a complex process. It takes time and practice and only highly educated fiber optic technicians can do the perform correctly with high yield ratio.

But fiber optic contractor installers for premise networks generally do not have the luxury of time or the pricey tools for this kind of termination. And that is when rapid termination fiber optic connectors come into handy.

Fast termination fiber optic connectors are specially designed for quick termination with no lots of experience required. A fiber optic contractor installer can do a fast termination within two~3 minutes.

There are a lot of different designs but the typical one particular such as Corning Siecor Unicam connector is like this:

The Unicam connector is pre-polished in factory with a fiber stub hidden inside the body of the connector. The installer then only requirements five steps to total an Unicam connector termination with market common high quality.

1. Strip the optical fiber to expose the 125um fiber cladding

two. Clean the exposed bare fiber with isopropyl alcohol and lint-totally free wipes

3. Cleave the fiber with a cleaver

four. Insert the fiber into the Unicam connector until it stops

five. Crimp the fiber onto the Unicam connector with a fiber connector crimper tool

A fiber optic contractor installer can make an Unicam connector termination inside 2 minutes. Compared to the normal epoxy approach (up to 30 minutes), that is 87% time saved.

Unicam connectors provide equivalent insertion loss overall performance as a normal epoxy and polish connector. Unicam connectors also meet or exceed the mechanical and optical efficiency specified by EIA/TIA 568.B.

Fiber Optic For Sale Co stocks all kinds of Corning Siecor Unicam connectors like Unicam ST, TKT Unicam CTS SF, Corning TKT Unicam, Unicam LC, Unicam SC, Unicam tool kit and TKT Unicam Elite.

To check out more, please go to: art institute of california san diego